Home
Products
Order Request
FAQ
Support
Resources
Contact Us
About Us
 
Generator Test Set
10KW, 125/250VAC, 50-70 Hertz Load Bank
 
Model 627
A Self-Contained Load Bank for Electrical Load Testing of AC Generator
 
 
What is a load bank?
 
A Generator Test Set, also known as a generator tester, a load bank or a dummy load, provides a fully controllable load that mimics the real load that the generator would see in normal operation. Its use allows the performance of both the engine and generator to be evaluated. It is also useful for restoring the full capacity to diesel powered generators by burning off the fuel deposits that have collected while operating under light loads. A third use is that of a UPS tester.

Now you can be sure that your generators and alternators are providing the output they should, and at the proper voltage and frequency. Generators up to 10KW can be loaded to full capacity. The generator test set combines two load banks in one, providing a 0-90A (0-10,800 watt) load at 120V, or 0-45A (0-10,800 watt) load at 240V. Larger generators can be tested using two test sets. This avoids purchasing a very large test set for only a small percentage of your generator inventory.
 
The Generator Test Set is comparable with those offered by Avtron, Power Systems and Simplex, but at a much lower cost!
 
Why pay more for less!    
 

PRICE:   $1,340.00

 
An Easy to Use Product at a Practical Price!

Fast and Easy
The test set is fully self-contained requiring only the adapters listed to mate with your generator.

Voltage Limits Identified
The proper voltage limits for both 120V and 240V generators are identified on the voltmeter face.

Continuous Load Controls

0-5A, 5A, 10A, 10A, 15A load controls are provided.

Ammeter Controls

Dual ranges of 0-10 and 0-50 amps.

Volt Meter Controls

Switchable between 120V and 240V inputs.

Direct Reading Frequency Meter
50-70 Hz (Electronic) frequency meter features a direct reading needle type indicator.

Self-Contained Cooling System
A self-contained fan allows the test set to operate on a continuous basis.

Built, Sold and Serviced in the U.S.

For over four decades Sotcher Measurement, Inc. has provided latest state-of-the-art electrical test equipment that is easy to use and maintain. Our customers rely on our products to verify the safety of the electrical devices they rent, use or manufacture. We feel this commitment very deeply. In response, we do our utmost to insure that the products we offer are of the highest quality and performance, consistent with good value.

We continue to design, manufacture and service all of our products in the United States. We are proud to be able to offer our customers fine American products that are easy to use at a practical price.

 

Go to SPECIFICATIONS

Input Voltage:       
120/240V, 50-70Hz, single phase
Protection:             
Circuit breaker protection provided on each section
Load Capacity:     
0-10,800 Watts
Duty Cycle:            
Continuous
Power Factor:        
Unity
Accuracies: 
 
  • Frequency Meter:
+/-3% Center
  • Volt Meter: +/-3% FS. 
  • Ammeter: +/-5% FS. 
Input Plug:      
125/250V, 50A, 3 pole, 4 wire (type CS6375)
Weight:            
Approximately 35 pounds.
Dimension:      
20 inches high, 16 inches wide, 10.5" inches deep
   

Go to OPTIONS

The following adapters allow you to mate the test set with receptacles commonly found on portable generators. Most of the adapters connect to the test set through the master adapter (40608). This saves you the cost of larger 50 amp connectors on every adapter. A good selection for most application would include the 40608, 40611,40612 and 40613.  
40601: Adapter, 125/250V, 50A, with Clips
$186
40608: Adapter, Master, 125/250V, 30A, Locking
$120
40610: Adapter, 125/250V, 20A, Locking, mates with 40608
$78
40611: Adapter, 125V, 30A, Locking, mates with 40608
$74
40611: Adapter, 125V, 20A, Locking, mates with 40608
$68
40612: Adapter, 125V, 15A, Non-Locking, mates with 40608
$63
40613: Adapter, 240V, 20A, Locking, mates with 40608
$68
40614: Adapter, 125/250V, 50A, Locking
$168
40616: Adapter, 125/250V, 50A, with Lugs
$202
40617: Adapter, 250V, 20A, Locking
$68
40619: Adapter, 125/250V, 50A, 3 Phase, Locking (two test sets)
$294
40690: Digital Volt Meter 
$252
40692: Digital Frequency Meter 
$252
40693: Digital Ammeter ( two required per test set) 
$356 ea.
   

Go to WHAT'S INCLUDED

Model 627 10KW Generator Test Set
• User's Manual
• One Year Parts and Labor Warranty
 

Go to RELATED PRODUCTS

 
 
 
 
 

 

HTML Hit Counter

Need Help?
Ask Our Experts!
 
 
"Definitely a good, top of the line product. Nobody questions the battery after it has been tested with the ni-cad battery tester. Can't beat the 573 when it comes to checking ni-cad batteries." 

Peter Reis
Fit-it Shop

 

Nationally Recognized Sotcher Measurement Inc. test equipment is in common use throughout the United States by major manufactures of power tools and appliances.