|
Need Help?
Ask Our Experts!
|
 |
 |
|
Hi-Pot/Ground Continuity Tester
|
|
0-2500 VAC Dielectric and Ground Continuity Tester
|
|
Model 566
TUV Certified Hi-Pot/Ground Continuity Tester for UL and CSA Compliance
|
 |
||
|
Hi-pot (hi pot, hipot or flash) testers and dielectric strength testers are typically used to perform electrical safety testing on components and products to insure that they comply with the safety requirements of UL, CSA, TUV and other standard certifying bodies.
The Model 566 combines both the Ground Continuity and Hi-Pot tests into a single tester. This is full featured tester, priced right, bringing state of the art technology to the testing of electrical products. Corded, uncorded and components can all be tested. Available options allow you test with up to 5,000 VAC or 2,500 VDC.
|
|||
|
This tester performs the same functions as models sold by Phenix, Slaughter, Rod L and Associated Research but at a much lower price and without the complex features that confuse production employees.
|
|||
|
PRICE: $870.00
|
 |
||
 |
|||
|
An Easy to Use Product at a Practical Price!
|
|||
|
Easy to Operate
The push of one button verifies both ground wire continuity and dielectric strength.
|
|
Adjustable Output Voltage
Adjustable over the range of 0-2,500 volts AC (or upto 5,000 VAC or 2,500 VDC with available options).
|
|
Direct Reading Leakage Meter
Fault current is displayed on a 0-10 milliamp meter (or optional 0-1.0 milliamp meter) allowing the operator to detect marginal products.
|
|
Ground Wire Continuity Verification
A switch on the rear panel allows the operator to control those products that are tested for ground wire continuity.
|
|
Test Duration Timer
Test Duration of 1 second, 60 seconds or continuous is selectable on rear panel.
|
|
Automatic Shut Down
Excessive leakage, dielectric flash over or ground continuity failure causes automatic shutdown of the output test voltage.
|
|
Visual and Audible Alarms
Both visual and audible alarms alert the operator of an out of tolerance condition. The reset button must be pushed to continue the operation.
|
|
Fast Response
The tester uses a fast response detection circuit to detect even short duration arcs or breakdowns that might occur. Once a fault is detected, the test circuit opens within milliseconds.
|
|
Meets UL's 120K Ohm Test
The UL 120K Ohm test requirement can be verified by using the built-in test button on front panel.
|
|
Built, Sold and Serviced in the
For over four decades Sotcher Measurement, Inc. has provided latest state-of-the-art electrical test equipment that is easy to use and maintain. Our customers rely on our products to verify the safety of the electrical devices they rent, use or manufacture. We feel this commitment very deeply. In response, we do our utmost to insure that the products we offer are of the highest quality and performance, consistent with good value.
|
|
We continue to design, manufacture and service all of our products in the United States. We are proud to be able to offer our customers fine American products that are easy to use at a practical price. |
| |
|
Input Voltage:
|
120VAC, 60Hz
|
|
Dielectric Voltage:
|
0-2,500VAC standard (See OPTIONS for Detail)
|
|
Dielectric Trip Limit:
|
5.0 mAAC, +/-5% standard
|
|
|
1.0 mADC, +/-5% (option 40568 0-2,500 VDC output)
|
|
Ground Continuity:
|
Approximately 12 VAC, 120 mA
|
|
Dielectric Transformer:
|
50 VA
|
|
Meters Accuracies:
|
+/-3%
|
|
Dimensions:
|
5.5 inches high, 12 inches wide, 10 inches Deep
|
|
Weight:
|
Approximately 18 pounds
|
|
|
|
|
40002 N.I.S.T Traceable Certification with Data
|
$110.00
|
|
40561 High Voltage Probe
|
$110.00
|
|
40537 0-5,000 VAC Output
|
$370.00
|
|
40538 0.1 Ohms, 10A Ground Bond
|
$230.00
|
|
40563 230V, 50Hz Input
|
$142.00
|
|
40566 Digital Dielectric Kilovolt Meter
|
$240.00
|
|
40567 Digital Leakage Meter
|
$240.00
|
|
40568 0-2,500 VDC Output
|
$220.00
|
|
40569 Retractable Ground Probe
|
$120.00
|
|
40570 0-3,000 VAC Output
|
$115.00
|
|
40577 0.1 Ohms, 25A Ground Bond
|
$340.00
|
|
40581 Remote PLC Control
|
$242.00
|
|
|
|
|
• Model 566 Hi-Pot/Ground Continuity Tester
|
|
• User's Manual
|
|
• One Year Parts and Labor Warranty
|
|
|