Home
Products
Order
FAQ
Support
Resources
Contact Us
About Us
Blog
 
Power Cord Test Station
High Speed Testing of Power Supply Cords
 
Model 461
Ideal for production testing of extension cords and power supply cords
 
This tester is loaded with features that are  assured to help your speed your production 
testing.  Meets all testing specifications of UL, CSA, TUV, VDE and JIS. 
 
A combination of any three receptacles or connectors can be installed on the front panel along with a touch plate. Quarter turn fasteners make them easy to switch as needed. 

PRICE:   Call for current pricing information!

An Easy to Use Product at a Practical Price!
This Tester Allows You to Conduct:
• Continuity
• Earth Bonding
• Polarity
• Short Circuit
• Dielectric Strength 
 
Compliance
The tester insures your compliance with the requirements normally specified by
UL, CSA, VDE, TUV, BSI and JIS. Test details should be verified to your specific requirements.
 
Multiple Test Receptacles
A combination of any three receptacles or connectors can be installed on the front panel. Each is mounted on a removable plate secured with quarter turn fasteners and internal connectors for easy replacement.
 
Automatic Operation
The test cords are cycled through the test sequence. Successful completion is signaled by a PASS ALL indicator. Failure of any condition shuts off all voltages and causes the test sequence to stop. A Buzzer and FAIL lamp signals the operator. The problem must be cleared and the RESET button pressed to continue. 
 
Dual Palm Switches
Palm switches are available for operator safety
 
Separate Touch Plate
An optional, remote touch plate is available allowing the operator to position it for easy use.  
 
Easy Calibration
Calibration controls are located on the rear panel. A special slow speed control allows all functions to be verified.

 

Built, Sold and Serviced in the U.S.

For over four decades Sotcher Measurement, Inc. has provided latest state-of-the-art electrical test equipment that is easy to use and maintain. Our customers rely on our products to verify the safety of the electrical devices they rent, use or manufacture. We feel this commitment very deeply. In response, we do our utmost to insure that the products we offer are of the highest quality and performance, consistent with good value.

We continue to design, manufacture and service all of our products in the United States. We are proud to be able to offer our customers fine American products that are easy to use at a practical price.

 

Go to SPECIFICATIONS

Input Voltage:       
120Volts, 50-70Hz, single phase
Continuity Test Current:            
Conductors: 1.5 amps at 6 VAC, rejecting resistances of 0.5 Ohms or greater
Gnd Wire: 25 amps at 6 VAC,  rejecting resistance of 0.1 Ohms or greater
Test Duration: 0.04 seconds
Dielectric Strength
 Performed in accordance with UL and CSA specifications. 0-2,000 VAC applied at zero crossing point. Rejects fault currents or flashover. Fault current rejection range adjustable over range of 1 to 10 Milliamps
Test duration: 1 Second 
   

Go to WHAT'S INCLUDED

Model 461 Power Cord Test Station
• User's Manual
• One Year Parts and Labor Warranty
 

Go to STANDARD FEATURES

 
 
"Definitely a good, top of the line product. Nobody questions the battery after it has been tested with the ni-cad battery tester. Can't beat the 627 when it comes to checking ni-cad batteries." 

Peter Reis
Fit-it Shop

 

Navigation

Nationally Recognized Sotcher Measurement Inc. test equipment is in common use throughout the United States by major manufactures of power tools and appliances.